What we did
- Made test board for hot detection again because previous one was taken apart
- Configured test board (different cRIO)
- Attached cRIO board onto robot
- Wired beaker and battery connector
- Connected chassis motors
Goals:
- Continue with hot detection
- Wire intake motors
- Connect pwm cables
- Maybe start putting reservoirs on
Attendance: Yuuma, Darius, Masanari, Camelia, Sara
Mechanical
Dremmeled holes so it would line up with the motor for intake,
Attached motors and chained sprockets for intake,
Attached intake to robot,
Tested intake with bumpers on
Attendance: Jackie, Kevin A, ZJ, Blake, Danielle, Dylan B
No comments:
Post a Comment